AUTONET TV

No Fueling Around (Fuel Filter Replacement)

A driver called in to the shop the other day saying his European sports sedan had an odd problem.  He was driving when his car started to slow down.  Applying more throttle didn't help.  He pulled over to the side of the road, shut the engine off and waited a few minutes before starting it up again.  It ran fine… for a couple of minutes.  Then the same thing happened.  He was able to finally get home by stopping and restarting, and he was calling to see if we could take a look at it. 

Turned out it was one of his car's fuel filters that choked up with debris so badly that enough fuel couldn't get through it.  When he stopped the car, enough fuel could flow through the unpressurized fuel line to supply enough fuel for a couple of minutes when he restarted his car. But then the pressure would cause things to clog again.  

There are other symptoms that point to a failing fuel filter. Perhaps your engine misfires, your vehicle is hard to start, or your fuel pump starts making odd noises. 
If you experience any of these signs, bring your vehicle in so we can have a technician check it out. 

Many vehicles have at least two fuel filters. One is a strainer that is part of the fuel pump in the fuel tank, and the other is in the main fuel line. Your vehicle's manufacturer recommends how often yours should be changed, but your driving habits and environment (such as dirty or dusty conditions) may mean yours will have to be replaced more often.  

The technician will also look to see if your vehicle might have another problem that's causing your fuel filter to fail more frequently than normal, such as corrosion in the fuel tank. 

Your engine needs fuel to run. Maintain the health of your fuel system and that will help keep you on the road to your destination.

Acheson Auto Works
8000 UNIVERSITY BLVD
CLIVE, IA 50325
515-223-4300

Out of Joint (CV Joint and Boot Replacement)

If you have a front-wheel-drive vehicle, it has components called CV joints which enable you to turn your wheels smoothly. The CV stands for “constant velocity.” In essence, it’s a set of gears that connect a shaft that allows power from the transmission to be sent to the wheels.  When you turn the wheels, no matter what angle, the input velocity rotation will be equal to the output. Thus, the name, CV (constant velocity) joint. Other vehicles with 4-wheel drive and all-wheel drive also use CV joints.  

If one of your CV joints isn’t working right, you may find your vehicle difficult to handle.  If one breaks, your vehicle may stop moving.  So, it’s important that CV joints be in top working condition.  The joints need a lot of lubrication, so they are surrounded by grease.  There’s a rubber enclosure around them called the boot which holds the grease in and protects CV joints from the elements. 
 
The biggest problems come when one of those rubber boots cracks.  Water and dirt can then get into the joint, causing it to wear down and lose all its vital lubrication.  It’s important to have your CV joints inspected regularly so a technician can spot cracks before the CV joints are ruined.  Sometimes just the boot can be replaced before any major damage is done.  But when the joint does go bad, it must be replaced.  

Signs your CV joint needs changing out? You might hear a clicking sound when you turn if the CV joint is worn out. You might notice some thick, black grease around your wheel or on the pavement where you park your vehicle.  You might also feel your vehicle vibrate when you’re going fast.

If you suspect you might have a bad CV joint, bring your vehicle in so a technician can determine what’s going on.  Keep your CV joints in good shape and reduce the risk of them seizing up at an inopportune time so you can avoid being stranded.

Acheson Auto Works
8000 UNIVERSITY BLVD
CLIVE, IA 50325
515-223-4300

Losing Your Cool (AC Condenser Replacement)

It’s always more comfortable in your vehicle when you can control temperature and humidity in the cabin. Air conditioning, which is standard on most newer vehicles, is a vital part of that comfort, and a key component of that system is the condenser.

The condenser converts the refrigerant gas into a liquid by cooling it down.  There are a few reasons the condenser can fail.  It can start leaking, which is usually caused by faulty seals and tubes, or debris from the road can damage it since it sits in a vulnerable spot at the front of your vehicle.  

Another way your condenser can be damaged is when bits of metal are released after your vehicle’s air conditioning compressor fails and are sent into the condenser. In both cases, you will have to have the condenser replaced as well as other components that are part of the system.

Here are signs that your condenser needs replacing.  When you turn on your air conditioning, it won’t make the air as cold as you’re used to it getting.  Or it may not get cold at all. Since other things can cause those symptoms, it’s best to bring your vehicle in to us to have one of our technicians determine where the problems are.

They’ll check the system’s pressure and thoroughly inspect for leaks.  If the problem is the condenser, they’ll replace it, refill the refrigerant, search for any more leaks in the system and give your air conditioning a final test to make sure it’s operating correctly.  

Keeping your air conditioning system working helps maintain the value of your vehicle.  It not only keeps the cabin cool when it’s hot outside, but also helps the defroster work properly and controls humidity in all seasons and climates.  Now, that’s very cool.

Acheson Auto Works
8000 UNIVERSITY BLVD
CLIVE, IA 50325
515-223-4300

Knowledge is Power (Battery Testing)

It’s likely happened to you once or twice.  You head to your vehicle, open the door, turn the key and… lo and behold, your battery is dead. Now you’re stranded, may have to get a jump or a tow, and you’ll definitely be late for wherever you were headed. While your vehicle may sometimes give you warning signs, other times it doesn’t.  

As many as one out of every four vehicles will have to have its battery replaced in the next 12 months.  If you don’t want to be surprised the next time your battery fails, consider having it tested.

There are different types of battery testing.  One measures voltage. Another checks for something called conductance.  By sending a certain type of electric current into the battery, it can measure how healthy your vehicle’s battery is.  There’s also a load test.  It checks how your battery is working while drawing power from it.  Newer test equipment found in professional service facilities can check for a number of different conditions using different methods. 

Most vehicle batteries last around five years.  It all depends on how you drive and in what conditions.  Extreme heat and cold will take their toll on a battery and shorten its life.  Stop-and-go city driving will also place batteries under more stress than smooth, continuous driving.  

So, what are some signs that your battery is starting to show its age? Well, the battery or alternator light may illuminate after you’ve started the vehicle or come on while you are driving.  If you’ve left lights or some equipment on and drained the battery, that can be very hard on it.

Because the battery is one of your vehicle’s most important components, it’s a good idea to have us check it regularly. In addition to examining the battery itself, a technician will also inspect the terminals and cables for corrosion, damage, fraying wires and loose connections.  It’s smart to have us do it before any extreme weather changes are expected or before long trips. In this case, knowledge truly is power.

Acheson Auto Works
8000 UNIVERSITY BLVD
CLIVE, IA 50325
515-223-4300

Reaching the Braking Point (Brake hose replacement)

If you notice your brakes aren’t working like they used to, that’s the kind of thing that’s important to have checked out soon.  That’s because your brakes are extraordinarily important to the safe operation of your vehicle. 

Sometimes you feel like your brake pedal is feeling a little soft or it’s lower than usual. Or you might feel like the brakes are on all the time, holding you back. Maybe when you release the brake pedal, it comes back up more slowly than usual. There are a few different problems that can cause your brakes to feel like any of those things, so bring your vehicle in to us and we can inspect them.

One possible cause of those brake issues is a damaged or worn-out brake hose.  Your hydraulic brakes work by carrying brake fluid to each of your wheels.  There are steel lines that carry the fluid most of the way, but because your wheels are moving all the time, a flexible hose is used to connect the steel lines and the brakes themselves.  

Sometimes those brake hoses leak, since there’s a lot of pressure inside when you use your brakes dozens or hundreds of times a day.  Road debris, aging, and corrosion at the hose fittings can loosen up that connection.  Sometimes the hoses can get blocked up if the interior lining separates from the outside. And sometimes, it’s simply a matter of the hose getting too old, and age eventually causes the rubber to fail.

When you experience brake problems, bring your vehicle in so we can have a technician take a look. Visual and manual inspections can usually pinpoint the problem areas.  The technician will look for corrosion and physical damage, plus run a pressure check.

For your vehicle to be safe on the road, your brakes need to be working the way they were designed to.  Stop. And think about it!

Acheson Auto Works
8000 UNIVERSITY BLVD
CLIVE, IA 50325
515-223-4300